Verano PA — Day-1 Device + Mesh HealthVerano PA — Salud Radio y MeshDay-1 Baseline

Each parent node in the Wirepas mesh — gateway sink, relay, or upstream node — supports at most 14 direct children. Grandchildren count against their immediate parent's slots, not against the grandparent's. Mid-layer relays can be saturated even when the gateway above them has plenty of headroom, so saturation has to be checked at every level of the topology, not just gateway-level. Once a parent crosses 14, additional devices either fail to join, get pushed to a worse parent at higher hop count, or thrash between slots — producing long travel times, retries, and growing data gaps.Cada padre en la mesh Wirepas soporta 14 hijos directos. Los nietos cuentan contra su padre inmediato. Rebalancear antes de saturar produce fallos silenciosos.

Dash-2 dedup: two AROYA serials sharing the same base number where one has a -2 suffix (e.g. H3440017858 and H3440017858-2) are ONE radio with two sensor heads, not two mesh nodes. They fill one slot on their parent. This report deduplicates by base serial before counting — counts are per unique radio, not per raw serial. (73 duplicate sensor-head entries collapsed for Verano PA.)Dedup dash-2: serials con sufijo -2 son una radio con dos cabezales — cuentan como uno.

🟢 ≤11 children — headroom  ·  🟠 12–13 — watch tier  ·  🔴 14 — at limit  ·  🔴🔴 >14 — over-subscribed

These are stricter than steady-state defaults because a healthy fresh deploy should look almost picture-perfect. Radios that already look degraded on day-1 will only get worse.Umbrales más estrictos que estado-estable — instalación fresca debe verse casi perfecta.

• Battery < 90% — fresh Li-SOCl₂ cells should be near 100% out of the boxBatería < 90% — celdas Li-SOCl₂ deben estar cerca de 100%
• Link quality < 80% — expect near-100% on radios with a clean parent connectionLink quality < 80% — cerca de 100% con conexión limpia al padre
• Silent-on-day-1 — device has not reported in the 24h window (this is the primary install signal)Silencioso día-1 — sin reporte en 24h
• Parent saturation ≥ 14 children — Wirepas hard limitSaturación padre ≥ 14 hijos — límite Wirepas

• Inventory: GET /devices/?facility=4742 · 175 raw serials.Inventario: 175 serials crudos.
• Dash-2 dedup: raw serials collapsed to 102 unique radios (73 sensor-head duplicates removed). Every count in this report is per unique radio, not per raw serial.Dedup dash-2: 102 radios únicos.
• Window: last 24 hours ending 2026-07-01 15:04 UTC. This is a day-1 install baseline pull, not a steady-state audit — 24 hours of data cannot support reliability judgments about churn rate, battery decay, or long-run mesh stability.Ventana: last 24 hours. Base día-1, no auditoría estable.
• Flag thresholds (fresh-install, stricter than steady-state): Battery <90% · Link <80% · Silent-on-day-1 (no data in 24h) · Parent saturation ≥14 children (Wirepas hard limit).Umbrales frescos: Batería <90%, Link <80%, silencio 24h, ≥14 hijos.
• Saturation counting: children counted per-parent at every mesh level. Grandchildren count against the immediate parent's slots, not the grandparent's — sink saturation (18/14) and repeater saturation (15/14) are separate findings.Nietos cuentan a su padre inmediato, no al abuelo.
• Not in scope: agronomic data (VPD, dryback, yield, crop steering). Device-side install audit only. Any VPD/VWC mention in this report is flagged as an install-artifact — a device correctly reporting the wrong environment because it hasn't been placed in its target zone yet.Sin datos agronómicos. Solo lado dispositivo.
• Re-audit date: 2026-07-08 (day-7). At that point the Wirepas mesh has had time to stabilize, silent radios have either joined or been physically confirmed missing, and probe placement will (should) be complete.Re-auditoría: 2026-07-08 (día-7).